chinese stock code:839562
off-line marking system

off-line marking system

hardware requirement:dlc board.

software requirement: ezcad3

1.enable multilayer, enable off line, set layer number to 8(for 8 files max. if 1 file, also need to enable multilayer, set the number to 1.)


2.edit the content in each layer.


3. click mark one time, the laser will not out, it is for saving the file into dlc.


4.after finishing clicking mark, break the usb connection with pc. repower the dlc board.

5. no need to connect the usb of pc, no need to open software. give the file selection signal (in1, in2, in8), then give the start marking signal(in0) to start marking. all the signals (in0, in1, in2, in8) are default for high lever ttl signal when without any connection (that means 1). when connect the input signals to gnd, it will change to low level ttl signal (that means 0).

file selection signals map below:(0 means signal short with gnd, 1 means not connect anything).

file

in8

in2

in1

in0(start mark)

file 1

0

0

0

1

file 2

0

0

1

1

file 3

0

1

0

1

file 4

0

1

1

1

file 5

1

0

0

1

file 6

1

0

1

1

file 7

1

1

0

1

file 8

1

1

1

1

 

after given the file selection signals, when not connect the in0 signal (means it is 1), the board will start marking on offline mode. all the signals are high level enable, so normally should connect gnd to stop marking, break gnd one time to start marking one time.

loading...